Digitakt + Typhon dreadbox + make noise 0 coast connection

Elektron Gear Digitakt
1

I am seeing a lot of information about this drum machine, and also a lot of people collaborating with it, so I would like to ask you about the connection of my digitakt, the typhon dreadbox and the make noise 0 coast …

Through the midi output I send signals to the make noise 0 coast, but when I do that, the Typhon dreadbox synth is inactive on the Midi THRU output, also I can’t use the internal sequencer synchronized with the digitakt tempo. It’s like I have to use it through the midi output, but in that case my make noise would be inactive. What I have tried is to connect the midi out of the typhon to the midi in of the digitakt and use it as the brain but it gets tedious.

What kind of connection can you think of that might be advisable to use the synthesizers together with the digitakt?

Sorry if I’m not posting in the right place, I’m new and would like to start understanding this forum.

Thank you very much.

2

Have you tried :

Digitakt MIDI OUT > Typhon MIDI IN

Typhon MIDI OUT (set to Through) > 0 Coast MIDI IN

Then you have to configure the MIDI on your respective devices.

3 Likes
3

I haven’t tested that setup yet, but if so, could I use the Typhon’s internal sequencer to send notes to Make Noise and, at the same time, receive them from the Digitakt? I understand that the Digitakt sequence would play back on both synths.

4

Usually, you can’t send MIDI notes if you use a MIDI Through. What’s coming out of the MIDI Through are the MIDI messages received on the MIDI In. So, Digitakt will have to be the Sequencer for both devices (Typhon and 0 Coast) for that setup.

1 Like